2 Safety Recalls — Kenworth T270 2010

No Latin American recalls are on record for the Kenworth T270 2010. The US NHTSA published 2 campaigns for the model sold there; they are listed below for reference.

Data last modified on · Source: National Highway Traffic Safety Administration (NHTSA)

How do I know if my T270 2010 is included?

The VIN (17-character chassis number) is on the windshield, the driver door and the vehicle registration. With it, the manufacturer or the agency can confirm whether your unit is included.

Search by VIN

US recalls that may apply

(2 NHTSA campaigns)

Campaigns published by NHTSA for the model sold in the United States. The Latin American version may differ: confirm with the VIN.

Driver assistance — NHTSA 20V199000 (April 6, 2020)

Date
Defect
PACCAR Incorporated (PACCAR) is recalling certain 2008-2019 Peterbilt 330, 335, 337, 340, 348, 365, 367, 384, 386, 387, 388, 389, 567, 579 and 587 vehicles and 2008-2020 Kenworth T170, T270, T370, T660, T680, T800, T880, and W900 vehicles equipped with NAMUX Software. In the event that the Anti-lock Brake System (ABS) loses battery and/or ignition power to the controller, the dash warning light for the ABS may not illuminate to warn the driver of the loss of ABS. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems," and 136, "Electronic Stability Control System on Heavy Vehicles."
Risk
If the driver unknowingly operates the vehicle without the ABS functioning, there would be an increased risk of a crash.
Remedy
PACCAR will notify owners, and dealers will update the NAMUX software within the cab control module, free of charge. PACCAR issued owners an interim notification on June 4, 2020. The recall began May 26, 2020. Owners may contact Kenworth customer service at 1-425-828-5888 or Peterbilt customer service at 1-940-591-4220. PACCAR's number for this recall is 20pbc AND 20KWB.
Units affected
460,515

See the full campaign

Engine/powertrain — NHTSA 10V150000 (April 15, 2010)

Date
Defect
KENWORTH IS RECALLING CERTAIN MODEL YEAR 2010 T270 AND T370 TRUCKS EQUIPPED WITH NON-LMS HUBS. THE SPINDLE NUT ATTACHING THE HUB AND BEARING TO THE AXLE SPINDLE (STEER OR DRIVE) MAY HAVE BEEN OVER-TORQUED DURING THE HUB INSTALLATION PROCESS.
Risk
AN OVER-TORQUE OF THE SPINDLE NUT MAY CAUSE THE BEARING TO SEIZE, POSSIBLY RESULTING IN THE OVERHEATING OF THE WHEEL END. AS A RESULT, A WHEEL END FIRE MAY OCCUR.
Remedy
DEALERS WILL REPLACE THE BEARINGS FREE OF CHARGE. THE SPINDLE AND HUB WILL BE INSPECTED FOR SCORING AND REPLACED IF NECESSARY. THE SAFETY RECALL BEGAN ON APRIL 23, 2010. OWNERS MAY CONTACT KENWORTH AT 425-828-5440.
Units affected
23

See the full campaign

Other years of the Kenworth T270

Questions about the Kenworth T270 2010

How many recalls does the Kenworth T270 2010 have?
No Latin American recalls are on record. The US NHTSA published 2 campaigns for the model sold there.

Information based on official data. If in doubt, consult your authorized dealer.