11 Safety Recalls — Altec Digger Derrick 2012

No Latin American recalls are on record for the Altec Digger Derrick 2012. The US NHTSA published 11 campaigns for the model sold there; they are listed below for reference.

Data last modified on · Source: National Highway Traffic Safety Administration (NHTSA)

How do I know if my Digger Derrick 2012 is included?

The VIN (17-character chassis number) is on the windshield, the driver door and the vehicle registration. With it, the manufacturer or the agency can confirm whether your unit is included.

Search by VIN

US recalls that may apply

(11 NHTSA campaigns)

Campaigns published by NHTSA for the model sold in the United States. The Latin American version may differ: confirm with the VIN.

Body/seats/visibility — NHTSA 25V562000 (August 29, 2025)

Date
Defect
Altec Industries Inc. (Altec) is recalling certain 2011-2025 Aerial Device, Digger Derrick, and 2022-2025 Service Body vehicles. The cable step wire rope assembly may be improperly secured, which can allow the cable entry step to detach from the vehicle.
Risk
A cable step that fails during use increases the risk of injury.
Remedy
Altec will provide owners with instructions to inspect the cable crimps. If the cables are improperly crimped, Altec will provide instructions and a kit to replace the wire rope assemblies. Repairs will be performed free of charge. Owner notification letters were mailed October 24, 2025. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3246.
Units affected
903

See the full campaign

Equipment — NHTSA 23V636000 (September 14, 2023)

Date
Defect
Altec Industries, Inc. (Altec) is recalling certain 2004-2023 DL42 and DL45 Digger Derricks. The incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fall.
Risk
An uncontrolled load falling increases the risk of injury to personnel or others nearby.
Remedy
Altec will replace the load holding valve, free of charge. Owner notification letters are expected to be mailed October 6, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is MAB 3113.
Units affected
53

See the full campaign

Equipment — NHTSA 19V365000 (May 13, 2019)

Date
Defect
Altec Industries Inc. (Altec) is recalling certain 2009-2019 DL/DM, DL/DMB, DH, D/2/3/4, and DC Digger Derrick vehicles. The slope indicator placard card may falsely indicate that the unit could be used without leveling on a 5 degree slope.
Risk
An operator may improperly set up the unit, making the unit unstable, thus increasing the risk of injury.
Remedy
Altec will notify owners, and issue CSN 719 to owners, instructing them to remove the incorrect placards, free of charge. The recall began July 2, 2019. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 719.
Units affected
1,036

See the full campaign

Equipment — NHTSA 19V127000 (February 27, 2019)

Date
Defect
Altec Industries, Inc (Altec) is recalling certain 2003-2019 Altec DL/DM, DL/DMB, and DC Digger Derrick vehicles. The pedestal tube welds may crack over time.
Risk
Unrepaired cracks may result in failure of the pedestal and uncontrolled movement increasing the risk of injury.
Remedy
Altec will notify owners and will provide repairs as necessary and a reinforcing kit. The recall began April 3, 2019. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 713.
Units affected
14,389

See the full campaign

Electrical system — NHTSA 18V791000 (November 9, 2018)

Date
Defect
Altec Industries, Inc. (Altec) is recalling certain 2008-2018 Altec AC18, AC23, AC26, AC30 and AC38 Cranes and D2B, D3A, D4A/B, DL42B, DT65 and DT80 Digger Derrick vehicles. The wiring on the 12V circuit from the chassis battery to the Power Distribution Module (PDM) may be insufficiently sized.
Risk
The insufficiently sized wire may overheat, increasing the risk of fire.
Remedy
Altec will notify owners, and dealers will replace the wiring to the PDM, with a larger wire and/or replace the circuit breaker, free of charge. The recall began January 9, 2019. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 703.
Units affected
331

See the full campaign

Electrical system — NHTSA 15V101000 (February 23, 2015)

Date
Defect
Altec Industries Inc. (Altec) is recalling certain model year 2012-2014 Digger Derrick and Aerial Device vehicles manufactured October 1, 2012, to June 30, 2014, and mounted on Freightliner chassis. In the event of a short circuit condition, the 30 amp breaker to the trailer relay module may react too slowly to prevent the module from overheating.
Risk
If the module overheats, there is an increased risk of a fire.
Remedy
Altec will notify owners, and dealers will replace the 30 amp circuit breaker with a 20 amp one, free of charge. The recall began on April 17, 2015. Owners may contact Altec customer service at 1-800-860-0183. Altec's number for this recall is CSN 612.
Units affected
5,142

See the full campaign

Electrical system — NHTSA 14V503000 (August 15, 2014)

Date
Defect
Altec Industries, Inc. (Altec) is recalling certain model year 2000-2013 Aerial Device and Digger Derrick trucks, equipped with Sure Power Battery Equalizers containing a particular epoxy sealing, aka 'potting', compound. The specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heat.
Risk
Once electrically conductive, the material is capable of melting and burning, increasing the risk of a fire.
Remedy
Altec will notify owners, and dealers will replace any affected battery equalizer, free of charge. The recall is expected to begin in September 2014. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 603.
Units affected
51

See the full campaign

Equipment — NHTSA 13V636000 (December 18, 2013)

Date
Defect
Altec Industries Inc. (Altec) is recalling certain model year 2009-2013 DT80, and model year 2011-2013 D2, D3 and D4 digger derrick models manufactured June 2009 through November 2013. The fasteners that hold the bracket for the feeder tube (the telescopic hydraulic tube that supplies pump flow to the auger) may become loose allowing the feeder tube to fall.
Risk
A falling feeder tube increases the risk of injury to people nearby.
Remedy
Altec will notify owners, and Altec service centers will install an upgraded feeder tube bracket and mounting hardware, free of charge. The recall began on February 19, 2014. Owners may contact Altec at 1-877-462-5832. Altec's number for this recall is CSN 591.
Units affected
661

See the full campaign

Equipment — NHTSA 13V390000 (August 28, 2013)

Date
Defect
Altec is recalling certain model year 2012-2013 Digger Derrick models D2/3/4 and DC/DL/DM manufactured June 2012 through July 2013. The bolts that attach the winch motor to the winch may not be properly tightened and may become loose.
Risk
If the bolts come loose, the winch motor may detach causing the load to fall, which may result in personal injury.
Remedy
Altec will notify owners and Altec service personnel will check and correct the torque of the winch motor bolts. The recall is expected to begin September 12, 2013. Owner's may contact Altec at 1-877-462-5832. Altec's recall number is CSN 586.
Units affected
1,743

See the full campaign

Equipment — NHTSA 13V141000 (April 11, 2013)

Date
Defect
Altec Industries, Inc (Altec) is recalling certain model year 2007-2012 DC, and DL/DM Digger Derrick utility trucks, equipped with boom tip winches using Tulsa Winch Group (formerly Gear Products) winch drums. In the affected vehicles, the winch drum could deform or fracture.
Risk
If the winch fails while in use, it could cause personal injury.
Remedy
Altec will notify owners and dealers will replace the winch drum, free of charge. The recall began on June 10, 2013. Altec's recall campaign number is CSN 574.
Units affected
1,057

See the full campaign

Equipment — NHTSA 12V423000 (August 30, 2012)

Date
Defect
Altec Industries, Inc. is recalling certain model year 2011-2012 Digger Derrick vehicles equipped with a PENGO digger extension shaft. A defect in the base material at the weld joint may result in a stress fracture through the applied weld of the drive hub to the hex bar material.
Risk
The stress fracture could cause the extension shaft to separate from the drive hub when digging, increasing the risk of personal injury and/or property damage.
Remedy
Altec will notify owners, and will inspect the PENGO digger extension shaft and, as necessary, replace the shaft, free of charge. The safety recall began on October 12, 2012. Owners may contact Altec Industries at 1-877-462-5832.
Units affected
2,193

See the full campaign

Other years of the Altec Digger Derrick

Questions about the Altec Digger Derrick 2012

How many recalls does the Altec Digger Derrick 2012 have?
No Latin American recalls are on record. The US NHTSA published 11 campaigns for the model sold there.